Dec 4 2001

Here’s what the passanger side looks like. There appears to be less rust on the inner wells compared to the other side.

The NPD fender on this side is also too tall on the door side of the fender, I had to remove about 1” from the bottom to fit. Also, since I didn’t replace the entire skin like the other side, it’s clear that the NPD fender’s body line is a lot sharper then stock. I will have to knock down the line a little so it will match the factory lines

I decided to only replace as little as possible. The cut is a few inches above the body line so it should be a lot easier to blend then the other side wich was on a curved portion.

Last Updated 10-10-2008